Aplikasi Scada System pada Miniatur Water Level Control

Authors

  • Antoni Susiono Faculty of Industrial Technology, Petra Christian University
  • Handy Wicaksono Faculty of Industrial Technology, Petra Christian University
  • Hany Ferdinando Faculty of Industrial Technology, Petra Christian University

:

https://doi.org/10.9744/jte.6.1.

Keywords:

miniatur water level control, PLC, SCADA software, PID controller.

Abstract

The paper discuss the implementation of Miniature Water Level Control which is made as a simulation from the industrial process. These project is equipped with SCADA to give a real visualisation of industrial process. To make the controlling and monitoring process easier, the project is made in small size (miniature model) which is easy to be brought (portable). .Miniature water level control was made as a plant which is controlled by PLC. There are two PLCs which is used, i.e. OMRON CPM1 and MODICON TSX Micro 3721. The computer, in this case the SCADA software, will visualize the process which is happened on the plant. From the experiment which is done, the plant can give the good response and keep the water level on the desired height. The system is stable when the height of water is the same as the set point. PID Control bias method (pump_voltage = bias + error) is used to run these system. Abstract in Bahasa Indonesia : Makalah ini menjelaskan pembuatan Miniatur Water Level Control yang digunakan sebagai salah satu bentuk simulasi dari proses yang terjadi dalam dunia industri. Project ini juga dilengkapi dengan SCADA sistem, yang akan memberikan gambaran lebih nyata tentang proses yang dimaksud. Untuk lebih memudahkan proses kontrol dan monitoring, maka bentuk dan ukurannya-pun dibuat dalam model miniatur yang mudah dibawa (portable). Miniatur water level control dibuat sebagai plant yang dikontrol oleh PLC. PLC yang digunakan ada 2 macam yaitu: OMRON CPM1 dan MODICON TSX Micro 3721. Sedangkan komputer dalam hal ini SCADA software akan memvisualisasikan proses yang terjadi pada plant. Dari pengujian yang dilakukan, sistem dapat berjalan sesuai dengan yang diinginkan yaitu mempertahankan level ketinggian air. Di mana pencapaian kestabilan terjadi apabila nilai sensor sama dengan set_point. Untuk menjalankan sistem digunakan metode kontrol PID dengan bias (teg_pompa = bias + error). Kata kunci: miniatur water level control, PLC, SCADA software, kontroler PID.

Downloads

Published

2006-05-22

Issue

Section

Articles