Miniatur Loading Arm Dock-3 PT Badak NGL Bontang dengan Sistem Emergency Shut Down (ESD)

Authors

  • Hany Ferdinando Jurusan Teknik Elektro, Universitas Kristen Petra
  • Handy Wicaksono Jurusan Teknik Elektro, Universitas Kristen Petra
  • Estevanus Kurniawan Pangkong Jurusan Teknik Elektro, Universitas Kristen Petra

:

https://doi.org/10.9744/jte.8.1.24-29

Keywords:

emergency shut down, PLC, loading arm

Abstract

Loading Arms in PT Badak NGL are used to distribute natural gas for shipping. The position of the ship cannot be fixed due to the wind, sea wave, stream flow, etc. If the distance is out of tolerance limit, then the Emergency Shut Down (ESD) system will be activated. ESD will release the part that is connected to the ship so that the whole distribution pipe is safe. The loading arms are controlled via Programmable Logic Controller (PLC) manually. The miniature of the loading arms is useful to train the new employees to operate them well. It is build with 1:10 ratio and controlled by PLC OMRON C200 HG. Several DC motors are used to move the arms while potentiometers are used as position sensors. The PLC will monitor whether the position is within tolerance limit or not. From the experiments, the ESD can be implemented with 16.48s for slewing motion and 16.5s for extension motion. Abstract in Bahasa Indonesia: Loading Arm di PT Badak NGL dipergunakan untuk menyalurkan gas alam ke kapal tanker. Posisi kapal tanker bisa jadi akan bergeser karena ombak, angin, arus laut, dll. Jika pergeseran posisi tersebut melewati batas toleransi yang diijinkan, maka sistem Emergency Shut Down (ESD) akan aktif. ESD akan melepaskan bagian valve yang melekat pada kapal sehingga pipa penyalur secara keseluruhan tidak tertarik oleh pergerakan kapal. Loading arm dikendalikan dengan PLC secara manual. Keberadaan miniatur ini akan menolong pekerja yang baru untuk mempelajari hal-hal yang mungkin pada pengoperasian Loading Arm tersebut. Miniatur dibuat dengan skala 1:10 dan dikendalikan oleh PLC OMRON C200HG. Sebagai penggerak dipergunakan motor DC. Potensiometer akan difungsikan sebagai sensor posisi sudut. PLC akan memonitor apakah sudut yang terbaca masih dalam batas toleransi atau tidak. Dari hasil pengujian, terlihat bahwa simulasi proses ESD dapat dijalankan dengan baik dengan waktu 16,48 detik untuk gerakan slewing dan 16,5 detik untuk gerakan ekstension. Kata kunci : Emergency shut down, PLC, loading arm

Downloads

Published

2009-10-21

Issue

Section

Articles